Welcome to the Medtronic Remote Monitoring program! We are excited to have you as a valued customer and look forward to assisting you in optimizing your experience with your new MyCareLink Monitor™. Let's run through some steps on how to properly set up your MyCareLink Monitor™.
Plug in the monitor and wait for a successful cellular connection. Do not press the “Accept" button until you have a connection.
If the monitor screen is dark, press the “Accept” button on the front of the monitor to wake-up the screen.
When the wake-up is complete, the monitor screen will show an image indicating that the monitor is ready to begin a transmission.
Press the “Accept” button. The monitor screen will show an image instructing you to pick up the reader.
When the monitor screen shows an image of a reader being placed over a device, hold the reader over your implanted device.
When the monitor begins reading data from your implanted device, the monitor screen will show a green progress bar, indicating that data is being sent from the reader to the monitor base.
| Note |
| While the monitor is communicating with your implanted device, remain still and make sure the monitor reader is placed over your implanted device. This process typically takes less than 3 minutes, but may take up to 12 minutes. |
When the monitor is finished communicating with your implanted device, the monitor will make two short tones, and the monitor screen will instruct you to return the reader to the monitor base.
The monitor will send your implanted device data to the CareLink™ network. The monitor screen will show a green progress bar indicating that data is being sent.
Your transmission is complete when the monitor makes two short tones and the monitor screen shows a green check mark image.
For MyCareLink Monitor™ setup with wireless devices, recommend the following:
If assistance is required, contact Medtronic Stay Connected at (866) 470-7709.