Transmission Verification for MyCarelink™ Relay 24960


Transmission Verification for MyCarelink™ Relay 24960

Welcome to the Medtronic Remote Monitoring program! We are excited to have you as a valued customer and look forward to assisting you in optimizing your experience with your new MyCareLink Relay 24960. Let's run through some steps on how to confirm your transmission was successful. 

 

Table of Contents

 

Sending a manual transmission

Use these steps to send information from your implanted heart device to the Medtronic Carelink™ network. Do so only at the request of your doctor or clinic.

Note
  • LINQ II (LNQ22) Does Not Send Manual Transmissions.

If you press the button and the bottom of the light ring flashes green 3 times with a 4 part tone playing, the communicator is busy. Wait and try again later.
  1. Press and hold the button for 2 seconds. When the light ring starts to spin and a short tone plays, release the button.
  2. The light ring continues to spin, and the progress bar will start to fill in, indicating that the data is being sent from your implanted heart device to the communicator.
  3. Stay within about 3 meters (10 feet) of the communicator until all the bars in the progress bar are lit. When this process is complete, the light ring and progress bar light up solid green. A short, 3 part rising tone plays.
Note
The communication process typically takes 3 to 12 minutes. Stay within range of the communicator during this process.
• After the transmission is successful, you can leave the area. The communicator will send your implanted heart device data to the Medtronic Carelink™ network where your doctor or clinic can access it.
• If the progress bar does not fill completely and a 3 part, descending tone plays, the transmission was not successful.

 

Back to top